Racing cars

Podium Advanced Technologies has been the technical driving force behind the SCG 003C project, engineering the entire vehicle around the specific targets required to compete at the Nürburgring 24 Hour race. The net result is four consecutive amazing seasons from 2015 to 2019, culminating in an overall pole position at the 2017 ADAC 24 Hours race.
In 2020 the SCG 004C, developed and built by Podium, made its debut at the 6 Hours of Nürburgring after few months from the start of development, and in September has raced at the 24 Hours Nürburgring, finishing 14th overall among the GT3 vehicles.

Racing cars

Podium Advanced Technologies has been the technical driving force behind the SCG 003C project, engineering the entire vehicle around the specific targets required to compete at the Nürburgring 24 Hour race. The net result is four consecutive amazing seasons from 2015 to 2019, culminating in an overall pole position at the 2017 ADAC 24 Hours race.
In 2020 the SCG 004C, developed and built by Podium, made its debut at the 6 Hours of Nürburgring after few months from the start of development, and in September has raced at the 24 Hours Nürburgring, finishing 14th overall among the GT3 vehicles.

Battery Management System Hardware features

  • Scalable: decentralized architecture BMS and several CSCs
  • Voltage level: 400V and up to >800V
  • Safety
  • Double μC with redundant communication (digital fault lines for OV, UV, OT)
  • Insulation monitoring unit
  • Crash detection, interlock signal, liquid leak detection
  • Interfaces
  • 2x CAN Bus
  • Low voltage interfaces
  • Analog and digital I/O’s
  • Channels for contactors and relays control
  • 2x Analog Current sensor interfaces
  • 4x HV measurement channels
  • Min 6 to max 16 cells voltage measurement per CSC
  • Max 8 temperature sensors per CSC

Battery Management System Software features

  • Cell limits monitoring
  • Power prediction (SoP)
  • SoC and SOH Evaluation
  • Balancing control
  • Contactor Control
  • Thermal Management Control
  • Data Logging
  • Operating Mode Control
  • Start-up and pre-charge
  • Driving
  • Charging
  • Shut down and discharge
  • Charger (AC & DC) Interfaces

Fill the form and upload your CV